Maxi-Cosi FERO - ANNEXE 7 Uživatelský manuál stáhnout pdf (Strana 51)

Sec. 4. OTHER FUNCTIONS 51

4. OTHER FUNCTIONS

4.1 Recognising the connected arm

When it is switched on, E32A SSR acquires the status of a series of input signals in order to identify the

type of arm it is connected to, and then configures itself accordingly. The resulting configuration, that is

maintained until the equipment is switched off, is indicated for 2 seconds by the 2 LEDs, that remain at the

beginning switched off for 2 seconds and then flash in synchronous way, as follows:

Arm type YELLOW LED/RED LED

Mida-Set 1 Flashing

Manual Mida Tool Eye 2 Flashings

Electrical Mida Tool Eye 3 Flashings

N.B.

Any operating mode other than that specified for the arm type indicates that the configuration is

incorrect and that an equipment alarm is active

4.2 SSR Output: Selecting Normally Open/Closed (JP4)

In addition to PIN 2 of J1, and Sink/Source mode, the P.O. output can also be supplied at the PINS 4 and 5,

and via an earth-free contact (Solid State Relay). In this case, E32A SSR can be programmed so that the

contact is Normally Open (NO) or Normally Closed (NC) by using jumper JP4 on the circuit board as

indicated in the Figure 4-1.

Figure 4-1. Selecting Normally Open/Closed on SSR Output.

NO mode

B (*)

NC mode

(*) Note: Default condition

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 133 134

Žádné komentáře

Maxi-Cosi FERO - ANNEXE 7 Uživatelský manuál Strana 51